Crypto Mining Shops: 10 Fast Safety Fixes You Can Do Today

If you’ve packed rigs into a room, you’ve built a small industrial space. Treat it that way. Here are ten fixes that stop injuries, fires, and downtime.

1) Stop overloading circuits

Risk: overheated conductors, nuisance trips, fire.
Fix: match rig load to circuit rating; use metered PDUs; label each run; keep 80% load rule.
Snap test: Open PictoSafe → photo of panel/PDUs → get spacing and clearance pointers.

2) Clear panel and egress

Risk: blocked shutoffs and exits.
Fix: 1 m (3 ft) electrical clearance; 36 in egress; mark floors; keep it clear.

3) Cable management

Risk: trips, damaged cords, heat build-up.
Fix: trays/hooks; no cords across walkways; no daisy chains; strain relief at plugs.

4) Vent and isolate heat

Risk: thermal throttling, fire load.
Fix: hot/cold aisles, duct out heat, fire breaks every bay, non-conductive dust vac.

5) Mount and rack right

Risk: tip-over and crush.
Fix: anchor racks; load heavy low; rated shelves; no balancing acts.

6) Fire readiness

Risk: small fire becomes big.
Fix: A-B-C extinguishers visible every 75 ft; inspect monthly; smoke/heat detectors.

7) Housekeeping

Risk: slips, trips, blocked air.
Fix: floors dry; cordons for wet work; bins for scrap ties/wrap.

8) Noise and hearing

Risk: fan walls can exceed safe levels.
Fix: measure; post hearing protection; rotate time in hot/noisy zones.

9) Stored energy and lockout

Risk: shock, live work.
Fix: one-page lockout for PDUs/panels; lockable disconnects; tag when servicing.

10) Vehicle/foot traffic

Risk: collisions with pallets/racks.
Fix: marked lanes, mirrors, cones; spotters; keep pedestrians out of forklift arcs.

We align to CSA/OHSA/CCOHS. Site rules and permits still apply.